Connection Of Modules In A Protection Box With Optional Power Supply - VibroSystM PCS-200ESB Installation Manual

4.2.3 Connection of modules in a protection box with optional power supply

Figure 28 : LIN-300 Series modules inside a protection box with optional power supply
The protective conductor terminal must be connected to a grounding point in compliance
with local regulations. Grounding is essential for safety purposes as well as to provide better
efficiency against ESD and EMI perturbations.
Copyright © VibroSystM Inc., 2010
An optional miniature power supply can be
•
installed inside the protection box.
When ordered with this type of power supply,
•
both LIN modules and power supply are pre-
wired to terminal blocks, to which two cables
must then be connected:
- the power source cable to the Power In
AC/DC terminals
- the signal output extension cable to the Out1
and Out2 terminals
Nominal input for miniature power supply:
•
AC Input voltage:100V
or
DC Input voltage:90V
Caution
LIN-300 Series Modules_Installation - Rev.4
- 240V ,
AC AC
(50 Hz - 60 Hz)
- 350V
DC DC
35