Table 3-4 Problems Using A Hard Disk Drive; Table 3-5 Problems Using The Cd Drive - HP j6700 Getting Started Manual

Table 3-4
The disk drive is not
accessible or does not
respond.
If problems persist, contact your system administrator or call your designated service
representative.
Table 3-5
The CD drive does not
respond to commands (for
example, mount or
swinstall).
If problems persist, contact your system administrator or call your designated service
representative.
Problems Using a Hard Disk Drive
Problem
Problems Using the CD Drive
Problem
Chapter 3
Common Problems and Solutions
Make sure that all SCSI devices are set to the proper SCSI
ID. (See the documentation that came with your SCSI
device.)
Check that all SCSI devices are correctly cabled. Check
that the SCSI bus is correctly terminated.
Follow the instructions in "Dealing with a Boot Failure"
later in this chapter.
If the disk drive is external to the system unit, make sure
that its power is turned ON.
Re-enter the commands and make sure you have typed
them correctly.
See the section "Running System Verification Tests" later
in this chapter to verify that the CD drive is functioning
properly.
Make sure power and data cables are connected.
Troubleshooting Your System
Solution
Solution
61