Verifying The Cd Drive Operation; Configuring The Cd Driver - HP j6700 Getting Started Manual

Getting Your System Running
Using Your CD Drive
7. Click on Remove in the Actions menu. Click Yes in the confirmation
window. This unmounts the CD. Note that it will take a short time for
the CD to be unmounted. The CD is successfully unmounted when
you see Unused in the Use column of the Disk and File Systems
window.

Verifying the CD Drive Operation

To verify that your workstation can communicate with the CD drive,
follow the steps covered in this section. Note that to perform the steps
required in this section, you must be superuser (root). If you cannot log
in as root contact your system administrator.
1. Log in as root.
2. Type the following command at the shell prompt and press
/usr/sbin/ioscan -d sdisk
After a few seconds the ioscan utility lists all of the I/O devices that
use the "sdisk" driver. Your CD drive should be among the devices
listed. A list similar to the following will appear:
H/W Path
===============================================
10/0/15/1.5.0
10/0/15/1.6.0
10/0/14/0.0.0
If ioscan does not detect any usable I/O system devices, such as the
CD drive, nothing is output and you are returned to the system
prompt. Since this indicates possibly that the driver for the CD drive
is not configured, read the subsequent section "Configuring the CD
Driver."
Configuring the CD Driver
If you reload software or rebuild the Instant Ignition system on your
workstation, you may need to reconfigure the HP-UX kernel to add the
CD driver. Use the SAM utility to add the CD driver and build a new
HP-UX kernel.
52
Class
disk SEAGATE ST39102LC
disk SEAGATE ST39102LC
disk TEAC CD-532E-B
Enter
Description
Chapter 2
: