Table 3-2. Problems Loading And Booting The Operating System; Table 3-3. Problems With The 802.3 Network - HP j6700 Getting Started Manual

Table 3-2
The LCD is lit, and text
appears on the screen,
but more than two
minutes have passed
with no sign of system
activity.
The system stops or
hangs while booting.
If problems persist, contact your system administrator or call your designated service
representative.
Table 3-3
Cannot reach other
systems on the network.
Applications that rely on
the network will not run.
If problems persist, contact your system administrator or call your designated service
representative.
Troubleshooting Your System
Common Problems and Solutions
Problems Loading and Booting the Operating System
Problem
Make sure that the system is not in soft power off mode by
pressing on the power switch located on the front of the
workstation.
Make sure that all external SCSI devices are set to the proper
SCSI ID. (See the documentation that came with your SCSI
device.)
Check that all SCSI devices are correctly cabled. Check that
the SCSI bus is correctly terminated.
Check that the LAN cable is connected and the LEDs on the
LAN connector are blinking.
Follow the instructions in "Dealing with a Boot Failure" later
in this chapter.
If the LCD displays a DIMM error, follow the instructions in
"Memory Failures" later in this chapter.
Problems with the 802.3 Network
Problem
60
Check the network connector on the back of the system
unit. Make sure the network cable or transceiver is
fastened securely to the connector.
Solution
Solution
Chapter 3