Table of Contents
Advertisement
[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Resetting Parameters to
[ENG] [2PWR,v2SMS] Resetting Parameters to Default Values
Resetting parameters of a device to default values is necessary in the next cases:
•
login and/or password for accessing a web interface of a device is lost;
•
no information about a current IP address of a device;
•
in certain cases after updating firmware of a device
This procedure sets all customizable parameters of a device to default values (IP address, access filters, user name,
password and other settings).
To reset parameters to default values, there is a need to consequently perform the next actions (for
PWR-220
v3/ETH device without a built-in battery):
•
switch off power of a device;
•
press the reset button «Reset»;
•
switch on power of a device keeping the «Reset» button pressed for 15-20 seconds;
•
release the button, all parameters of a device are reset to default values
To reset parameters to default values, there is a need to consequently perform the next actions (for
PWR-220
v2/SMS device with a built-in battery):
•
press and keep the «Reset» button pressed for more than 5 seconds (use a pen/stilys/pencil, etc.);
•
release the «Reset» button, CPU LEDs near Ethernet ports will blink, all parameters of a device are reset to
default values
Short-term clicking the «Reset» button will reboot a device (for
built-in battery).
On default, a device has the next parameters:
a NetPing 2/PWR-220
[ENG] [2PWR,v2SMS] Resetting Parameters to Default Values
Default Values
a NetPing 2/
a NetPing 2/
v2/SMS device with a
–
Advertisement
Table of Contents
