My E-Pc Doesn't Start Properly - HP E-PC C10 User Manual

My e-pc doesn't start properly

The e-pc doesn't power on
Have you checked that...
The e-pc's AC adapter is correctly connected
If your e-pc's AC adapter has a voltage
switch, that it is correctly set
The AC adapter is working properly
I I I I f f f f t t t t h h h h e e e e p p p p r r r r o o o o b b b b l l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c on on on ont t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u p p p p po po po por r r r t t t t p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r
The e-pc hangs during start-up
Have you checked that ...
Your memory modules are of the correct type
That you have not made any changes to the
e-pc's Setup program that may be causing
the problem
I I I I f f f f t t t t h h h h e e e e p p p p r r r r o o o o b b b b l l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c o o o o n n n n t t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u p p p p p p p p o o o o rt rt rt rt p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r
The power-on self test detects an error
An on-screen error message during the POST means that your e-pc has a configuration problem.
Have you checked...
The part of your configuration with which the
Power-On Self Test has detected an error
How


Connect the AC adapter to a working power outlet,
then connect the AC adapter to the rear of the e-pc


Disconnect the AC adapter.
1
Select the correct setting on the voltage switch
2
(if applicable).
3 Reconnect the AC adapter.
4 Start the e-pc.


1 When you power on the e-pc, check that the
light on the On/Off button comes on.
2 If nothing happens, contact your authorized
support provider. The original AC adapter may
have to be replaced.
How


1 Disconnect the e-pc's AC adapter.
2 Remove the e-pc's main cover.
Replace the memory module with a known working
3
memory module.
4 Reconnect the e-pc's AC adapter and start up the
e-pc.


Enter the Setup program by pressing F2 when
1
prompted during start-up. Refer to page 38.
Reload the default Setup values by pressing F9.
2
Press F10 to exit Setup saving changes.
3
How


For more specific troubleshooting information, see
1
"General problems" beginning on page 20.
2 If you still have a problem, run HP e-DiagTools (refer
to page 30).

My e-pc doesn't start properly

15