Advertisement
Step 4: Frame Assembly
Part 2
B: Place End Wall between 2 (2677) Narrow Panels noticing the panel orientations. The tops and bottoms of
the panels should be flush. Make sure the panels are square then using the pilot holes as a guide pre-drill with
a 3/16" (4.8 mm) drill bit and fasten the back (2677) Narrow Panel to End Wall and End Wall to the front (2677)
Narrow Panel with 4 (WL5) Wafer Lags per side. (fig. 4.4, 4.5 and 4.6)
Fig. 4.4
Top View
2677
Back
Notice back
(2677) Narrow
Panel overlaps
End Wall
Flush
WL5
Fig. 4.6
Flush
Pre-drill using 3/16" drill bit for 1/4 x 2½ Lags
Use #8 x 7/8" Truss screws for the Jamb Mounts
Do not cover the 2 holes with Jamb Mounts
End Wall
Wood Parts
2 x
Narrow Panel
2677
End Wall
Back
2677
8 x
Notice End Wall
overlaps front
(2677) Narrow
Panel
SIZE
A
SCALE:1:50
Flush
Hardware
Wafer Lag
WL5
27
2677
Front
Flush
WL5
DWG. NO.
Details
WEIGHT:
SHEET 1 OF 9
Front
2677
Fig. 4.5
WL5
x 4 per
side
REV.
Advertisement
