Removing A 733-Mhz Processor From The Heatsink; Figure 3-26. Removing The Metal Bracket From The Back Of The Processor - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

Removing a 733-MHz Processor from the Heatsink

To remove the processor from the heatsink:
1. Perform the steps in the "Service Preparations."
2. Remove the side access panel.
3. Perform the steps in the "Removing a Processor" section.
4. Slide the metal bracket on the back of the processor to the left 1 and
remove the bracket.

Figure 3-26. Removing the metal bracket from the back of the processor

Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Before removing the side access panel, ensure that the Workstation
is turned off, all cables are disconnected from the back of the Workstation, and
the power cord is disconnected from the grounded AC outlet.
Removal and Replacement Procedures 3-31
1