Table of Contents
Advertisement
[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Plugging External Sensors
[ENG] [2PWR,v2SMS] Plugging External Sensors
It is prohibited to plug sensors and external modules into NetPing devices when a power supply is on!
Configuring a device and receiving notifications from sensors can be seen in the document
description».
Description of Contacts
To make plugging of sensors to a device convenient, a terminal block is used. To fix wires in a terminal block, use a
slotted screwdriver with a slot width of 2,5 mm. Pinout of contacts on a terminal block looks like the next:
Contact
I1-I4
SC
Description
IO line 1-4
Contacts of a digital bus i2C, synchronization line
[ENG] [2PWR,v2SMS] Plugging External Sensors
«Firmware
–
Advertisement
Table of Contents
