Table of Contents
Advertisement
[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Plugging External Sensors
Plugging a door sensor
A sensor is a «dry contact», therefore the order of connecting wires is irrelevant. The number of plugged sensors is
limited only by a number of free IO lines.
Second wire
Depending on the output (I1-I4) on a terminal block, where a sensor is plugged in, it is displayed on the same
channel IO1-IO4 in a web interface of a device.
IO lines, to which sensors are connected, must be configured as the «input» in an interface of a device!
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Plugging
a leakage sensor
The number of plugged sensors is limited only by a number of free IO lines.
Colored Loop
Yellow (white)
Depending on the output (I1-I4) on a terminal block, where a sensor is plugged in, it is displayed on the same
channel IO1-IO4 in a web interface of a device.
IO lines, to which sensors are connected, must be configured as the «input» in an interface of a device!
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Loop
First wire
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
Green
Red
Black
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
Contact Name
I1-I4
G
2
Contact Name
I1-I4
G
+
G
2
[ENG] [2PWR,v2SMS] Plugging External Sensors
. Maximum allowable length of a
. Maximum allowable length of a
–
Advertisement
Table of Contents
