Over Clock Running - JETWAY 694TCS User Manual

This motherboard Provides a ZIF
motherboard should have a cooling FAN attached to prevent overheating. If this is not
the case, then purchase a correct cooling FAN before you turn on your system.
WARNING! Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it
may cause the processor and motherboard overheat and damage, you
may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown
below. The notched corner should point toward the end of the level. Because the CPU
has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
When you put the CPU into the ZIF socket. No force require to insert of the CPU, then
press the level to Locate position slightly without any extra force.

2-3-3 Over clock Running

WARNING! This section is for experienced motherboard installer only. Over clocking
can result in system instability or even shortening life of the processor.
After setting the Jumper JK1, JK2, BSEL0, BSEL1 you can choose over clock running by
BIOS CMOS SETUP UTILITY.
"Miscellaneous Control" you will see the screen as below then.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Socket 370.
Colden Arrow
Pentium  III
Socket 370
CPU ZIF Socket 370
When you entered CMOS SETUP UTILITY, choose
Miscellaneous Control
11
The CPU that comes with the