Care & Maintenance - ECS NEATSX User Manual

Care & Maintenance
Backing up the NEATsx Disk
As with any program disk, a back-up copy should be made and
the program run from the copy. The master disk should be stored in a
safe place. The NEATsx disk is not copy protected. If your system has
a hard disk drive the contents of the NEATsx disk can be copied to it
and run from there.
To make a back-up copy of the NEATsx, use the standard
DOS COPY command. This should be used as follows (with some
variation depending on the disk drives being used). The following
command line will copy the contents of the disk in drive A (in this
case the NEATsx, disk) to the disk in drive B. After placing the
NEATsx disk in drive A of your system, type:
COPY A:*.* B:
This will copy the contents of the source disk to the disk in
Drive B. If your system has only one floppy disk drive, a message will
appear during the procedure, asking you to replace the source disk (the
disk you are copying from) with the destination disk (the disk you
wish to copy to).
Care & Maintenance
69