ECS NEATSX User Manual page 71

Reset Switch
The NEATsx has a connector for a Reset button. If this has
been connected to the front panel of your system case the button can
be used to restart your system without turning the power off. Pushing
the button will cause your system to restart from the memory test. It is
then necessary to reboot your operating system software before you
can continue.
Changing Processing Speed
Hardware Switch
The NEATsx has a connector for a hardware processor speed
switch. If this has been connected to the front panel of your system
you can use it to switch between the maximum processing speed (of­
ten referred to as "Turbo") and the secondary slower processing speed.
Pushing the switch on the panel changes the speed. If the higher speed
is in use and your front panel has the appropriate indicator light, the
LED indicator will light up while the high-speed mode is in use.
Installation & Operation
65