ECS NEATSX User Manual page 57

20MHz NON-INTERLEAVE:
3 .0 WATT STATE, memory requirement is 60NS
4.1 WATT STATE, memory requirement is 80NS
The wait-state is dependent on both the speed of RAM and the
processor operating speed, determined by jumper JP2. The list notes
the required RAM speed to use a particular wait-state setting. The
RAM speed used and the selected wait state must be compatible; oth­
erwise, the system may halt when rebooting. If such occurs, press
<INS> as the system power is turned on to clear the erroneous set­
tings. Run Quickset again to establish desired settings.
3. SET EMS MEMORY
This section requests information about EMS memory. The
following is the SET EMS MEMORY menu as it appears on the
screen.
1. Disable LIM EMS (no EMS function)
2. Enable LIM EMS (select memory in EMS function)
JM EMS: Lotus-Intel-Microsoft Expanded Memory Specification
V4.0
Software Setup
51