Resetting The Internet Module; Installation Wizard - Inter-Tel EncoreCX Manual

EncoreCX
Internet Module Manual
·
Internet Module Configuration takes you to the Configuration screen.
·
Get Configuration receives all settings and updates the corresponding fields in the management
system.
·
Set Configuration sends all management system settings to the Internet Module.
·
Restore Factory Defaults restores all settings to the original factory settings.
· Back takes you back to the previous screen.
For some configuration changes to take effect, a warm reset must be performed on the Internet module.
A prompt will appear on the EncoreCX Programming and Maintenance software screen requesting a
reset.

Resetting the Internet Module

The Internet module must be reset for some configuration changes to take effect. It can be reset via
the Programming and Maintenance software or by using the RESET button on the Internet Module
MDF. For reset via the Programming and Maintenance software, go to the main system screen and
select Diagnostics \ System Resets \ Internet Module \ Warm Reset.

Installation Wizard

The installation wizard allows you to quickly and easily set up an Internet connection.
Before you use the wizard, you must have the following information on hand.
·
Will DSL or Broadband be used to access the ISP?
·
If DSL is to be used, get the following information. This will be provided by your ISP.
- Username
- Password
- Which of the following protocols are used by the DSL modem ?
·
PPPoE (Point-to-Point Protocol over Ethernet)
· Dynamic IP address assignment
·
Static IP address assignment
If static IP addressing is used, skip the DSL Wizard and proceed to the DSL Profile.
·
If Broadband is to be used, get the following information. This will be provided by your ISP.
- Username
- Password
- Which of the following protocols are used by the Cable modem ?
·
PPPoE
·
Dynamic IP address assignment
·
Static IP address assignment
If static IP addressing is used, skip the Broadband Wizard and proceed to the Broadband
Profile.
4