Hubble Nursery Pal Skyview Quick Start Manual

What's in the box?
1 x Baby Unit (Camera)
1 x Parent Unit
1 x Magnetic Mount
2 x Power Adapters
1 x Top Clamp
1 x Bottom Clamp
1 x Gooseneck
4 x Poles with Stand Base

How do I install the Digital Video Baby Monitor?

Connecting the Power Supply for the Baby Unit:

- Insert the DC plug of the power adapter into the DC socket on the back of the Baby Unit
- Connect the other end of the power adapter to a suitable electrical outlet
- The baby unit turns on and the power indicator lights in Blue colour. Note: Only use the
supplied power adapter (DC5V/1000mA).

Fixing the magnetic mount on the wall:

- Mark the position of the screw holes on the wall
- Install wall anchors (not provided) suitable for the wall type and mounting screws if needed
- Fasten the mounting screws (not provided) on the wall
- Position the cable behind the base before attaching the base on the wall

Connecting the Power Supply of the Parent Unit

- Connect the small plug of the power adapter to the parent unit and the other end to the
electrical outlet. Only use the enclosed adapter (5VDC/1000mA)

How long does the battery last for the parent unit?

A rechargeable battery (Lithium ion battery 2000mAh) allows the parent unit to be used when
not plugged into an electrical outlet. The battery provides up to 5 hours operation of the Parent
Unit. We recommend charging for at least 16 hours before first use, and when the Parent Unit
indicates the battery is low.

How do I install the crib mount?

A crib mount with cable management is included which mounts directly to most cribs to allow
better viewing. Assemble and install the crib mount using the following steps:
- Join the 4 poles and the support base together. Note: Each pole is connected with power
cord inside, take care not to damage the power cords when removing the poles from the
box and during installation
- Fasten the top clamp either vertically on the upper rail or horizontally on the slats
Nursery Pal Skyview