Own Ship Functions Box - Furuno FMD-3100 Operator's Manual

2. OPERATIONAL OVERVIEW
2.1.5

Own ship functions box

The own ship functions box shows information about own ship, enables offset, and does
TM reset.
Offset button
WGS 84 button
RNC info
appears here.
• [Offset] button: See section 18.8.1. This button is only operative in the Voyage navi-
gation mode.
• [WGS84] button: Convert position data between datum; go to selected position on the
current chart. Click the button to display the dialog box shown below. To convert a po-
sition from one datum to another, select the datum source at the [Source] pull-down
list and enter position. Select the datum to convert to at the [Converted] pull-down list
then click the
verted] pull-down list. To go to a position, click a [Go To] button.
• ENC info: ENC chart info appears here.
No indication: ENC chart is currently displayed.
"ENC data available": Currently, RNC chart is shown, but ENC chart is available.
"Non-ENC data": Non-official ENC material, in yellow characters. See section 3.21.
• RNC info: "RNC data" appears (in yellow) when raster chart is in use.
• TM/CU status:
"TM/CU Reset": True motion reset is active. (Chart is stationary and own ship moves
on the chart.)
"TM Reset off": When dragging the chart; true motion is OFF. To restart true motion,
click the indication,
"Ship off screen": Ship is out of the display area.
2-10
button. The position on the chart selected is shown below the [Con-
ENC info
appears here.
TM/CU status