How To Take Sample Data Of Banknotes - Amrotec MIB-1 Series Service Manual

PART THREE
3. COLLECT/CAPTURE DATA OF BANKNOTES AND UPGRADE THE MACHINE
1) How to take sample data of Banknotes for Software Improvement
While MIB-1 Currency discriminator machine has high-recognition rate for US banknotes, if certain circulated
banknote (denomination / issue) is not being counted by MIB-1 for some reasons, such as bit worn out, please take
sample data of that banknote and send to AMROTEC for investigation and possible software improvement.
However, it should be noted that currency discriminating machine as MIB-1 is not capable of reading UNFIT
banknotes, such as overly soiled or worn out, tape on the banknote or glued, overly creased or overly folded and so
on. Same applies to if any suspect banknotes not read by MIB-1 (Except those highly sophisticated Super Counterfeit
Dollar bill which have most of the security features as genuine banknotes).
How to take data sample for genuine or Suspect Banknotes:
1. First insert USB stick in the port located in the back of the
machine. Make sure that USB drive is empty or have enough
memory space.
2. A new symbol will appear on the MIB-1 LCD Display screen next to where the piece count (PCS) shows.
See screen shot. Once the Symbol appears, machine is ready to capture the data samples of non-
recognize genuine banknote or suspect banks. Follow the steps below:
[MIX] mode is used for capturing
genuine banknotes data
[COUNT] mode is used to capture suspect
banknote data.
4