Error Code & Solutions - Amrotec MIB-1 Series Service Manual

PART FOUR
4. ERROR CODE AND SOLUTIONS
When MIB-1 is first turned on, the machine will enter in to self-check
(Initialization) automatically. If LCD screen displays any of the following error codes, it
is because that there may be dust on the surface of sensors or sensors blocked by
notes or other particulates or paper clips and so on. Solutions: Clean the dust with
brush or soft cloth or remove the banknotes if in the bill path, and then restart the
machine. Contact AMROTEC is problem continues to persist.
Error code Trouble position
EO1
EO2
EO3
EO4
EO5
EO6
EO7
During the counting, when LCD screen appears with any of the following Error codes
and the machine stops, please perform:
Error code
E1
E2
E3
E4
E10
E11
E12
E13
E14
E15
E20
E21
E22
E23
E24
Left counting sensor
Right counting sensor
Left repeated sensor
Right repeated sensor
Note-receiving sensor
Note-feeding sensor
Breadth sensor
Bill UV sensor error
Bill double error
Chain notes error
Half notes error
Bill CIS sensor signal lose
Denomination error
Bill denomination error
Bill facing recognize error
Bill size recognize error
Bill towards recognize error
MT error
MG1 error
MG2 error
MG3 error
MG4 error
Trouble
Shooting
9