Advertisement
TT extension installation
●
The extensions can be trimmed to fit at either end, make sure to chamfer the ends of the bolting section if you
cut them as there will be exposed aluminum. The round end of the extensions have been reamed to a 7cm
depth, if you choose to cut these very short you may need to gently round file the inside of the extension to suit
the outside diameter of your shifter.
●
Bolt the extensions to the base bar by passing the M5 bolts into the connection point under the bar
●
Ensure assembly compound is applied between all mating parts in this area
●
Extension to adapter torque is 8Nm
Pad to Bar Torque is 4Nm
●
(6Nm max)
Advertisement
