Advertisement
Basebar Routing
●
Consult with your mechanic about non-typical Di2 wiring such as sprint shifters etc, you may require more than one wire per
bar end
●
Pull your Di2 wires through to the center section of the bar prior to routing hydraulic hoses
It is typically simpler to pull through your hydro hoses through the stem/Basebar, then extend them through to the bar ends
●
●
Loop the hydro hoses back from the center of the basebar/fork interface, using a great deal of caution to not kink them. This
loop is very important and a great deal of care must be taken with this. Once the loop has been made, gently press it down
into the vacant space in the basebar, to be covered later in the assembly process
Advertisement
