Ac Power Supply - EcoFlow WAVE User Manual

Short press the Mode button to switch to Cooling Mode; short press again to switch to Fan Mode (Fan Mode is
only available in Car Charging or Solar Charging Mode)
Air supply mode Refrigeration mode
No-Drain Function
This product has a self-evaporating, drain-free system that sprays condensation water from the evaporator to
the condenser for heat dissipation and evaporation, eliminating the need for frequent drainage in environments
with low humidity.
Note: Some water droplets may not evaporate and it is normal for the hot-zone outlet to blow out a few water
droplets. The no-drain function drains most of the condensation, but a small amount of water may still remain in
the base. To avoid retaining water that may breed bacteria, tilt the machine slightly when not in use to completely
drain the remaining water through the drainage port.
Shut Down When Full Function
The product is equipped with a function that shuts it down when it is full of water. When the ambient humidity
is high, the air conditioner condensation cannot be completely drained by the no-drain system and the internal
water level gradually rises. The machine has an overflow to prevent excessive water storage. After reaching a
predetermined water level, the function is triggered to shut down the machine and prompt the user to connect
the drainage tube to manually drain the water.
Note: Tilting the product can affect detection of the water level. Excessive tilting can cause the water level to be
inaccurately detected, leading to unnecessary shutdown or the product not shutting down when full of water.
The product should be positioned as horizontally as possible during use.

3.4 AC Power Supply

An AC power supply can be connected to power or charge the product.
When the product is connected to AC power, press and hold the main power button and the machine will enter
Standby Mode. If a battery is connected, the battery pack will be charged at maximum power.
When the product is connected to AC power, short press the main power button and the device will operate
normally. If a battery is connected, the product will prioritize providing power to the air conditioner via the built-in
intelligent charging algorithm while simultaneously charging the battery pack at the optimum power.
7