Table of Contents
Advertisement
INDICATORS AND KEYPAD BUTTON
1
The following LED indicators are located on the camera (Figure 2):
1
On – camera is connected to power
POWER
2
On – Ethernet link is established. Blinking - data transmission
NET
3
On – Loaded tasks will be executed based on their trigger parameters
ONLINE
4
1
On – Output 1 is on
OUT
5
2
On – Output 2 is on
OUT
6
3
On – Output 3 is on
OUT
7
LED blinks during image and flash memory access
BUSY
8
Camera Reset: See Note below
BUTTON
To trigger the Camera Button event, press and release the button (Internal
software event trigger only)
Note: Camera Reset will restore the factory camera settings. This includes deleting all user settings on the camera
and resetting the camera's IP Address and Mask to the factory default.
To Reset the Camera
1. Turn off power.
2. Press and hold the Camera Reset button.
3. Turn on power.
4. When all the LED indicators turn on and remain lit, release the Camera Reset button.
5. Wait approximately 30 seconds for the camera to restart.
8
2
8
Figure 2 - Indicators
T4x-SERIES QUICKSTART GUIDE
3
4
5
6
7
Advertisement
Table of Contents
