Disposal Requirements - Foster BCT Original Operation Instructions

GB
Important Note to the Installer:
If you are not the user please pass this document on to them as
it contains important guidelines on operation, loading, cleaning
and general maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual
Current Device; such as a Residual Current Circuit Breaker (RCCB) type socket, or through a
Residual Current Circuit Breaker with Overload Protection (RCBO) supplied circuit.

Disposal Requirements

If not disposed of properly all refrigerators have components that can be harmful to the
environment. All old refrigerators must be disposed of by appropriately registered and licensed
waste contractors, and in accordance with national laws and regulations.
Start-Up and Operation
(For Modular units please refer to the separate Install & Erection Instructions)
After unpacking, clean and allow the cabinet to stand for 2 hours before turning on
(cleaning directions supplied within this manual). Ensure the cabinet is situated where
neither hot nor cold air sources will affect its performance. Make sure that a minimum clearance
of 150mm around the cabinet is available for ventilation and effective operation. There is no
minimum clearance for above the cabinets. Connect the unit to a suitable mains power outlet and
turn the supply on. Please note that the BCT36 will require a 16amp supply and the BCFT36 and
both 51kg models will require a 3 phase supply.
Do not plug or unplug the unit with wet hands.
Initialisation
screen
After power is
applied to the unit the
controller display will
show the initialisation
screen. This will
only show for a few
minutes stating both
'Booting' and then displaying the software
version at the bottom of the screen. When the
controller has completed initialisation the screen
will revert to the 'Home Screen'.
Touchpad Icons
Cycle Description
Chill Cycle Symbol
Cycle Progression Bar
Detail Information
Stop Button
(Some icons or switches are only visable during adjustment, when activated by parameters or through
1
Home Screen
This is shown
after initialisation
and when no
programmes are
running. From
this page a cycle
can be launched.
Select the cycle
type by pressing the relevant cycle button and
then press 'Start'. This page also shows the
date, time and current air temperature and
allows access to the 'Settings Home Page' and
'Information' function.
Time Elapsed
operation/manual selection).
Air (T1) Temperature
Day & Current Time
Surround Signal
Information Button