Names And Functions Of Parts; Front And Document Feed And Eject Trays - Canon imageFORMULA ScanFront 220 Instructions Manual

3.

Names and Functions of Parts

The names and functions of the parts of the ScanFront 220/220P are shown below.
❏ Front and Document Feed and Eject Trays
ScanFront 220
ScanFront 220P
a Power Switch
Use this to turn the power ON.
* Use the Power OFF button on the touch panel to turn the
power OFF.
b Power Indicator
Lights when the power is ON.
c Lock Lever
Locks the panel unit. Pull the lever toward you to unlock
the panel unit. (See p. 2-10.)
d Document Feed Tray
Pull out the feed tray to match the length of the document.
(See p. 2-4.)
e Document Guides
Adjust these to match the width of the document.
p. 2-7.)
f Panel Unit
Open this when there is a paper jam or to perform
maintenance. (See p. 2-10.)
g Touch Panel
Touch this screen to operate the ScanFront.
h Document Eject Tray
Open this tray when using the ScanFront. If scanned
documents are likely to fall out of the tray, open the tray
extension. If scanned documents curl in the document
eject tray, remove the entire tray.
i Fingerprint Authentication Sensor (Only Available
with the ScanFront 220P)
This fingerprint sensor is for fingerprint registration and
authentication. (See p. 2-11.)
j Feed Selection Lever
Use this lever to change the feed method for documents.
(See p. 2-5.)
1-8
Chapter 1 Before Use
(See p. 3-4.)
(See p. 3-4.)
(See
(See p. 2-4.)