Front Panel; Rear Panel - Numark NS4 FX User Manual

Front Panel

1
1. Headphone Outputs: Connect headphones to these 1/4" (6.35 mm) and 1/8" (3.5 mm) jacks
for monitoring the signal. The headphone volume is controlled using the Cue Gain knob.
2. Crossfader Assign: Use these switches to route the audio playing on the corresponding
channel to either side of the crossfader (A or B), or bypasses the crossfader and sends the
audio directly to the Program Mix (center, Off).
3. Mic 2 Input: Connect a standard dynamic microphone to this 1/4" (6.35 mm) jack.
4. Mic 2 Level: Adjusts the volume level of the Mic 2 Input .
5. Mic 2 Tone: Turn this knob to adjust the tone of the Mic 2 Input. Turn left to increase the Low
frequency tone, or turn right to increase the High frequency tone.

Rear Panel

3
1
2 4
1. Power Button: Press this button to turn NS4 FX on and off. Turn on NS4 FX after all input
devices have been connected and before you turn on amplifiers. Turn off amplifiers before you
turn off NS4 FX.
2. Power Input: Use the included power adapter (12 V DC, 2 A, center-positive) to connect NS4
FX to a power outlet. While the power is switched off, plug the cable into NS4 FX first, and then
plug the cable into a power outlet.
3. Cable Restraint: You can secure cables to this restraint to help avoid disconnecting them
accidentally.
4. USB: Use a standard USB cable (included) to connect each USB port to an available USB port
on a computer. This port sends USB MIDI data to control various software parameters.
5. Main Output (XLR): Use standard XLR cables to connect this output to a PA system or
powered monitors. The level of this output is controlled with the Main knob on the top panel.
6. Booth Output (RCA): Use standard RCA cables to connect this output to a booth monitoring
system. The level of this output is controlled by the Booth knob on the top panel.
7. Aux Input: Connect a line-level device to these RCA inputs. Use the Mic 1/Line controls on the
top panel to select this input and adjust its level and tone.
8. Mic 1 Input: Connect a standard dynamic microphone to this 1/4" (6.35 mm) input. Use the
Mic 1/Line controls on the top panel to select this input and adjust its level and tone.
2
5
6
2
3
4 5
7
8
7