Connection Diagram - Numark NS4 FX User Manual

Setup
1. Place NS4 FX on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to "zero".
3. Connect any input devices (microphones, CD players, etc.) to NS4 FX's Mic or Aux Inputs.
4. Connect NS4 FX's Main Outputs and Booth Outputs (if using) to power amplifiers or
loudspeakers, and connect headphones to the Headphone Outputs.
5. Plug all devices into power and connect NS4 FX's USB port to a computer's USB port using
the included USB cable.
6. When powering everything on, power on your devices in the following order:
•
(1) Any input sources, (2) your computer and NS4 FX, (3) any amplifiers, speakers, or
output devices.
7. Locate the Serato DJ Lite installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ'ing!
10. When powering everything off, power off your devices in the following order:
•
(1) Any amplifiers, speakers, or output devices, (2) your computer and NS4 FX, (3) any
input sources.

Connection Diagram

Items not listed under
Power
Computer
Headphones
Introduction > Box Contents are sold separately.
Loudspeakers
Booth Monitors
Aux
Device
Microphone
3