Concentric Vertical Kit Installation - Immergas VICTRIX OMNIA Manual

Mounting the horizontal intake-exhaust kit Ø 80/125 (Fig. 20)
To install the kit Ø 80/125 one must use the flanged adapter kit in order to install the flue system Ø 80/125.
1. Install the flanged adaptor (2) on the central hole of the appliance, positioning gasket (1) with the circular projections downwards in
contact with the appliance flange, and tighten using the screws contained in the kit.
2. Engage the bend (3) with the male side (smooth) to the end stop on the adapter (1).
3. Fit the Ø 80/125 (5) concentric terminal pipe with the male side (smooth) to the female side of the bend (4) (with lip seals) up to the end
stop, making sure that the internal (6) and external wall sealing plates (7) have been fitted; this will ensure sealing and joining of the
elements making up the kit.
3
2
1
Extensions for Ø 80/125 horizontal kit. Kit assembly (Fig. 21)
The kit with this configuration can be extended up to a max. length of 32 m, including the terminal with grid and excluding the concen-
tric bend leaving the appliance.
If additional components are assembled, the length equivalent to the maximum allowed must be subtracted.
In this case the special extensions must be requested.

1.17 CONCENTRIC VERTICAL KIT INSTALLATION

Type C configuration, sealed chamber and fan assisted
Concentric vertical intake and exhaust kit.
This vertical terminal is connected directly to the outside of the building for air intake and flue gas exhaust.
The vertical kit with aluminium tile enables installation on terraces and roofs with a maximum slope of 45% (approx. 25°) and
the height between the terminal cap and half-shell (374 mm for Ø 60/100 and 260 mm for Ø 80/125) must always be observed.
32
4
5
6
The adapter kit includes (Fig. 20):
C
13
N°1 Gasket (1)
N°1 Adapter Ø 80/125 (2)
The Kit Ø 80/125 includes (Fig. 20):
N°1 Concentric bend Ø 80/125 at 87° (3)
N°1 Int./exhaust
Ø 80/125 (4)
N°1 Internal wall sealing plate (5)
20
N°1 External wall sealing plate (6)
The remaining kit components must not be used
concentric terminal
C
13
21