Immergas VICTRIX OMNIA Manual page 69

Complete calibration activation.
Nominal heat
output: with the function active, the boiler carries out the procedures required to calibrate the appliance at the nominal heat output.
At this stage the display features flashing icons: "
output (99%) is displayed; once the parameters are detected and stabilised, the "
utes), meaning that the nominal heat output settings have been set.
Press and hold buttons "
42
The display will show two dashes "--" flashing. Now enter the password "62" to
activate the complete calibration (enter the first digit by pressing the 1-2 buttons
( ) and the second digit by pressing the buttons 5-6 (
43
Press the " " key to activate calibration.
Once activated, the complete calibration function has four phases:
44
" and " " and the operating temperature alternated with the current operating heat
Only after the "
(Par. 3.10) or switch to the next heat output parameter by pressing the "
button.
45
" and " " for more than 5 seconds.
" symbol will start flashing (this may take a few min-
" symbol flashes is it possible to change the CO
).
value
2
"
69