Vacmaster UB0212EUK Manual page 14

GB
4. WrapFree Brushroll
The motorised floor head is fitted with a WrapFree brushroll, which actively removes the hair
from the brushroll when vacuuming. If you see any hair wrapped around the brushroll, continue
cleaning, ensuring the brushroll On/Off button is switched ON and the brushroll is rotating on low
pile carpets or tile floors. Hair will be removed from the WrapFree brushroll and be sucked into the
dust bag.
If you hear a sound change when vacuuming, check for blockages or objects caught in the
brushroll.
1) Turn off the vacuum cleaner and unplug the power cord.
2) Check and rotate the brushroll counterclockwise to remove the blockage (Fig. 34).
NOTE: If any fibers remain wrapped around brushroll, carefully cut them and remove from the
brushroll.
5. Pre-Motor Filters
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before reinstalling
them to prevent liquid from being drawn into electronic parts.
NOTE: When the cleaning of filters no longer restores vacuum cleaner suction to full power, or the
filters are worn or broken, replace the filters. To purchase filters, contact the After Sales Helpline.
1) Remove the dust bag as outlined in the Dust Bag Replacement section (page 13) (Fig. 35).
2) Remove the foam filter cover and the foam filter (Fig. 36).
3) Wash the filter in cold water, rinse and dry thoroughly allowing to air dry for 24 hours.
NOTE: DO NOT operate without foam filter installed.
DO NOT wash in the dishwasher.
DO NOT install foam filter if damp.
4) Reinstall the foam filter into the foam filter cover and slide it into the slots until it is in place
(Fig. 37). Press the cover down to lock it into place until a 'click' can be heard (Fig. 38).
NOTE: Replace the foam filter if it is worn or broken.
5) Reinstall the dust bag as outlined in the Dust Bag Replacement section (page 13).
6. HEPA Exhaust Filter
It is recommended to clean the HEPA exhaust filter with cold water every year.
1) Remove exhaust filter cover by pulling the tab (
2) Remove the HEPA exhaust filter (
3) Wash with cold water only, DO NOT use detergent or soap. Allow to air dry. Allow parts to dry
24 hours before putting back into vacuum cleaner.
NOTE: DO NOT operate without post-motor filter installed.
DO NOT wash in the dishwasher.
DO NOT install the filter if damp.
4) Replace the foam filter to the HEPA exhaust filter first. Then replace the HEPA exhaust filter
with foam filter into the vacuum cleaner (Fig. 41).
) at the bottom of the cover (Fig. 39).
10
) together with the foam filter (
11
14
) (Fig. 40).
12