Vacmaster UB0212EUK Manual page 11

Brushroll Status Indicator
The brushroll indicator status light:
Colour
Green The brushroll is spinning and working as intended.
There is a jam in the brushroll area. Turn off and unplug
Red
the vacuum. Remove any blockages in the nozzle.
No Lights The brush-roll is not active.
Bag Fill Level Indicator (Fig. 16)
As the dust bag fills with dirt and debris, the indicator will illustrate the level of bag fill. Once all
LEDs are illuminated red, the bag should be replaced. See page 13 for the dust bag replacement
instructions.
Bag Fill Level Indicator
One LED light (furthest left), green continuous Lights progressively illuminate to show the bag
Two LED lights, orange continuous
Three LED lights, orange continuous
Four LED lights, red continuous
LED lights, red flashing
ABOVE FLOOR MODE
1) Place the vacuum cleaner in the upright locked position.
2) Press the wand release button and lift the wand for above floor cleaning (Fig. 17).
3) Choose the desired attachments and insert into the wand (Fig. 18).
4) Turn on the vacuum cleaner by pressing the On/Off Button.
5) Once you have completed vacuuming, press the On/Off button again and unplug the power
cord from the power outlet.
NOTE: The attachments can also insert directly onto the handle (Fig. 19).
CAUTION: When using attachments, be careful not to over stretch the suction hose to avoid
causing the vacuum cleaner to tip over.
LIFT OFF MODE
NOTE: Make sure the power cord is fully released from the cord hooks before using Lift Off
function.
1) Place the vacuum cleaner in the upright locked position.
2) Press lift off button and lift up the vacuum cleaner body away from the floor head (Fig. 20).
3) Press the wand release button and lift up the wand for cleaning stairs or other hard to reach
places.
4) Choose the desired attachments and insert it into the wand (Fig. 21).
5) Turn on the vacuum cleaner by pressing the On/Off Button.
6) Once you have completed vacuuming, press the On/Off button again and unplug the power
cord from the power outlet.
Status
is filling. Replace the bag when all LED lights
begin to illuminate red continuously.
The dust bag is full, replace with a new one; or
the air path is blocked, please check and clean.
11
Bag Fill Level
GB