Setting Gv-Fr Panel To Be A Door - GeoVision GV-FR User Manual

3.1.2 Setting GV-FR Panel to be a Door

Once GV-AS Controller has been connected to GV-ASManager, you then need to connect
GV-FR Panel to GV-AS Controller. To do so, follow the steps below.
Note: The following procedures are only applied to GV-FR Panel V1.2.0 or later.
1. On the menu bar of GV-ASManager, click Setup and select Devices.
2. Double-click the controller that GV-FR Panel to be connected to and select a Door. This
dialog box appears.
3. Select GV-FR Panel from the Entrance and/or Ext dropdown list, in accordance to your
installation site.
4. Type the IP address, Port number, Account ID and Password of the GV-FR Panel.
5. Click OK. The GV-FR Panel is connected to the controller and GV-ASManager is also
connected with GV-FR Panel.
To verify the connection on GV-FR Panel:
6. On the GV-FWC / Controller Setting page (Notify Settings > GV-FWC/Controller), you
should find an entry, for example, [ASManager] Door 4-FR (In), written back from GV-
ASManager to indicate which controller IP and which door is connected to.
Access Control Integration
3
18