3-8-1.1 Irqs Activities; Miscellaneous Control - VIA Technologies P4M890DMP VT8237R Plus User Manual

3-8-1.1 IRQs Activities

CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
IRQ5 (LPT 2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values

3-9 Miscellaneous Control

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
Flash Write Protect
PnP OS Installed
Resources Controlled By
x IRQ Resources
Assign IRQ For VGA
Assign IRQ For USB
Maximum payload size
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system can not boot. The
settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot
and Plug and Play compatible devices. However, this capability means absolutely nothing
IRQs Activities
ON
Disabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
Disabled
F6:Optimized Defaults
PnP/PCI Configurations
Enabled
No
Auto(ESCD)
Press Enter
Enabled
Enabled
4096
F6:Optimized Defaults
42
Item Help
Menu Level >>>
F1:General Help
F7:Standard Defaults
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults