Installing The Antenna; Installing The Belt Clip - Kenwood NX-1200NE2 User Manual

INSTALLING THE ANTENNA

Screw the antenna into the connector on the top of the
transceiver by holding the antenna at its base and turning it
clockwise until secure.

INSTALLING THE BELT CLIP

If necessary, attach the belt clip using the two supplied
M3 x 8 mm binding screws.
Note:
◆ If the belt clip is not installed, its mounting location
may get hot during continuous transmission or
when left sitting in a hot environment.
◆ Use the Phillips #2 screwdriver.
CAUTION
◆ Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver. Acrylic
ester, which is contained in these glues, may crack the transceiver's back
panel.
7
Antenna
Belt clip
M3 x 8 mm
screws