Kenwood NX-1200NE2 User Manual page 49

Remote Control [NXDN/ DMR]
Allows you to remotely control a specified transceiver from the transceiver.
In the NXDN and DMR systems, it allows you to operate the transceiver directly,
send a remote control message and control the target transceiver.
Note:
◆ The Remote Control is a software option.
In Remote Control Mode, the following remote control message can be sent.
Remote Stun: Send a Remote Stun Message to the designated Transceiver and
make the Transceiver unusable.
Remote Revive: Send a Remote Revive Message to the designated Transceiver
and release the Stun state of the Transceiver.
Remote Kill: Send a Remote Kill Message to the designated Transceiver and
make Transceiver inoperable and prevent any operation.
Remote Monitor: Send a Remote send request message to the specified
Transceiver, Individual Call from the Transceiver to the requester, cancel Mic Mute
and send it continuously.
Radio Check: Send a Radio Check Message to the specified Transceiver and let
the Transceiver send an ACK.
49