Installing The (Optional) Antenna; Installing The Belt Clip - Kenwood NX-3220E2 User Manual

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the connector on the top
of the transceiver by holding the antenna at its
base and turning it clockwise until secure.

INSTALLING THE BELT CLIP

If necessary, attach the belt clip
using the two supplied M3 x 8 mm
binding screws.
Note:
If the belt clip is not installed, its
●
mounting location may get hot
during continuous transmission or
when left sitting in a hot
environment.
CAUTION
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver's back panel.
16
Optional
antenna
Belt clip
M3 x 8 mm
screws