Kenwood NX-1200NE2 User Manual page 24

Button Lock [Analog/ NXDN/ DMR]
Locking the transceiver button operation. This function prevents the incorrect
operation of the transceiver by physical contact while carrying the transceiver,
such as around the waist.
PF Button:
Press the programmed button to lock the transceiver buttons.
• Beep A (1 beep) sounds.
Press the button again to unlock.
• Beep B (2 beeps) sounds.
• While Button Lock is on, operate a button that has been locked. "LOCKED" is
displayed for 1 second.
• Even if a button on the transceiver is pressed while the Button Lock is
enabled, a Button-entry Error Tone (1 beep) sounds.
• Whether each button operation is targeted for the Button Lock can be
configured by your dealer. The following buttons are targeted for the Button
Lock when each configuration is enabled:
- Selector, Front Buttons, Side Buttons, Volume Control, and PTT Switch.
• The following will still function and can be operated as per normal.
- Backlight, Battery Status, Button Lock, Call Response, Clear, Emergency,
Function, Monitor, Monitor Momentary, Lone Worker, Squelch Off, and
Squelch Off Momentary.
Call 1 ~ 6 [Analog/ NXDN/ DMR]
Allows you to send assigned signaling from Call 1 to Call 6.
PF Button:
Press the programmed button to send a message or initiate a call.
Calling Alert [Analog]
Allows you to send a calling alert to the other party. Calling alert tones help
identify yourself to party members and inform them that you are calling.
PF Button:
Press the programmed button to send an Alert tone to a receiver.
24