Table of Contents
Advertisement
AquaLift
Self-Cleaning Technology
®
AquaLift
Self-Cleaning Technology is a first-of-its-kind cleaning
®
solution designed to minimize the time, temperature, and odors
that ordinarily come with traditional self-cleaning methods. With
AquaLift
Self-Cleaning Technology, an exclusive coating on the
®
interior of the oven is activated with heat and water to release
baked-on soil. To use AquaLift
wipe out loose debris, pour water into the oven bottom, and run
the AquaLift
Self-Cleaning cycle. When the cycle finishes in under
®
1 hour at a lower temperature than in traditional self-cleaning
methods, just wipe out the remaining water and loose debris.
See the "Clean Cycle" section for more detailed instructions. For
additional information, frequently asked questions, and videos
on using AquaLift
Self-Cleaning Technology, visit our website at
®
http://whirlpoolcorp.com/aqualift.
Surface Temperatures
When the range is in use, all range surfaces may become hot,
such as the knobs and oven door.
Baking Drawer
When the oven is in use, the drawer may become hot. Do not store
plastics, cloth, or other items that could melt or burn in the drawer.
Oven Vent
The oven vent releases hot air and moisture from the oven and
should not be blocked or covered. Do not set plastics, paper, or
other items that could melt or burn near the oven vent.
Preheating
When beginning a Bake, Convect Bake, or Convect Roast cycle,
the oven will begin preheating after Start is pressed. The oven
will take approximately 12 to 15 minutes to reach 350°F (177°C)
with all of the oven racks provided with your oven inside the
oven cavity. Higher temperatures will take longer to preheat. The
Preheat cycle rapidly increases the oven temperature. The actual
oven temperature will go above your set temperature to offset
the heat lost when your oven door is opened to insert food. This
ensures that when you place your food in the oven, the oven
will begin at the proper temperature. Insert your food when the
Preheat tone sounds. Do not open the door during Preheat before
the tone sounds.
KEY USAGE TIPS
Self-Cleaning Technology, simply
®
Ceramic Glass Cooktop Cleaning
To avoid damaging the cooktop, do not use steel wool, abrasive
powder cleansers, chlorine bleach, rust remover, or ammonia.
1. Remove food/residue with the Cooktop Scraper.
For best results, use the Cooktop Scraper while the
■
cooktop is still warm but not hot to the touch. It is
recommended to wear an oven mitt while scraping the
warm cooktop.
Hold the Cooktop Scraper at approximately a 45° angle
■
against the glass surface and scrape the residue. It will
be necessary to apply pressure in order to remove the
residue.
Allow the cooktop to cool down completely before proceeding
to Step 2.
2. Apply a few dime-sized drops of affresh
the affected areas.
Rub affresh
Cooktop Cleaner onto the cooktop surface
®
■
with the blue Cooktop Cleaning Pad. Some pressure is
needed to remove stubborn stains.
Allow the cleaner to dry to a white haze before proceeding
■
to Step 3.
3. Polish with a clean, dry cloth or a clean, dry paper towel.
Repeat steps 1 through 3 as necessary for stubborn or
■
burned-on stains.
The Complete Cooktop Cleaner Kit is available for order including
the following:
Cooktop Scraper
■
affresh
Cooktop Cleaner
®
■
Blue Cooktop Cleaning Pads
■
See the "Accessories" section for part numbers and information
on ordering.
5
Cooktop Cleaner to
®
Advertisement
Table of Contents
