Direct Console Access; Telnet Console Access - HP ProCurve 4202vl-48G Installation And Getting Started Manual

If you want to operate the console using a different configuration, ensure you
change the settings on both the terminal and on the switch. Change the switch
settings first, then change the terminal settings, and reestablish the console
session.

Direct Console Access

To connect a console to the
switch, follow these steps:
1. Connect the PC or
terminal to the switch's
Console Port using the
console cable included
with the switch. (If your
PC or terminal has a 25-
pin serial connector, first
attach a 9-pin to 25-pin
straight-through adapter
to the PC end of the
console cable.)
2. Turn on the terminal or
PC's power and, if using a
PC, start the PC terminal
program.
3. Press the Enter key two
or three times and you
will see the copyright
page and the message
"Press any key to
continue". Press a key,
and you will then see the
switch console CLI prompt.

Telnet Console Access

To access the switch through a telnet session, follow these steps:
1. Ensure the switch is configured with an IP address and that the switch is
reachable from the telnet workstation (for example by using a Ping
command to the switch's IP address)
2. Start the telnet program and connect to the switch's IP address.
3. You will see the copyright page and the message "Press any key to
continue". Press a key, and you will then see the switch console CLI
prompt.
Installing the Switch 4200vl Series
console port
Power
Fault
console cable supplied
with the switch
PC running a terminal
emulator program, or
a VT-100 terminal
Figure 2-14. Connecting the console port
Installation Procedures
ProCur ve
Self T est
Switc h 4202vl
Sta
J8772A
1 2
Reset Clear
Fan Powe
Console Auxiliar y Port
10/1 00Base-TX P orts — all por t s a
1 3 5 7 9 11
Link Mode Link
ProCur ve
10/1 00-T
vl Module
J8765A Link 2 Mode 4 6 8 10 12 Link
2-21