Download Print this page

HP ProCurve 4202vl-48G Installation And Getting Started Manual: Verify The Switch Passes Self Test

Hp procurve 4202vl-48g: install guide.
Hide thumbs

Advertisement

Installing the Switch 4200vl Series
Installation Procedures

4. Verify the Switch Passes Self Test

After you have installed any modules and the optional second power supply,
but before mounting the switch in its network location, you should first verify
it is working properly by plugging it into a power source and verifying it passes
its self test.
If you have installed a second power supply, repeat these procedures with the
second power supply to verify it works correctly also.
1.
Figure 2-5. Connecting power to the Switch
N o t e
The Switch 4200vl Series do not have a power switch. They are powered on
when the power cord is connected to the switch and to a power source.
If your installation requires a different power cord than the one supplied with
the switch, please see the "Installation Precautions" on
2.
2-12
Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a properly grounded electrical
outlet.
connect power cord
to power connector
Check the LEDs on the switch and on each of the switch modules. The
LED behavior is described on the next page.
If the LED display is different than what is described, especially if the
Fault LED stays on for more than approximately 120 seconds or it starts
flashing, the self test has not completed correctly. Refer to chapter 4,
"Troubleshooting" for diagnostic help.
page
2-5.

Advertisement

Troubleshooting

   Related Manuals for HP ProCurve 4202vl-48G

This manual also for:

Procurve 4208vl-64g, J8773a, J9030a, J9064a

Comments to this Manuals

Symbols: 0
Latest comments: