HP ProCurve 4202vl-48G Installation And Getting Started Manual page 31

Insert the power supply into
the opening, then slide it all the
way in until it connects to the
switch. The power supply face
plate will be flush with the
back face of the switch.
Figure 2-3. Installing a power supply
Once the power supply is installed, ensure you tighten the four retaining
screws that hold it in place. The screws can be tightened with either a flat-
bladed or Torx T-10 screwdriver. Be careful to not overtighten the screws.
Figure 2-4. Tighten power supply retaining screws
Installing the Switch 4200vl Series
Installation Procedures
tighten the four screws
2-11