HP ProCurve 4202vl-48G Installation And Getting Started Manual page 29

insert module into the
guides and slide it in until
it is fully inserted
Figure 2-1. Installing a module
the module is fully inserted when
the module bulkhead is contacting,
or very close to contacting
the face of the switch
Figure 2-2. Tighten module retaining screws
tighten the retaining screws on
the module until they are secure,
but do not overtighten them
Installing the Switch 4200vl Series
Installation Procedures
"Low-force" connector.
High insertion force is not
needed and should not be used
for best results,
push near both screws
2-9