Table of Contents
Advertisement
10.2.1. Adjusting the Output Line Level
To adjust the output line level:
1. Open the Analog Output Configuration tab in the OUTPUT section.
2. Initially, the cursor will highlight all output channels. To accept this, rotate the encoder to move the
cursor to the current reference level.
3. Alternatively, pressing the encoder on the channel strip allows the selection of an individual channel.
4. Move the cursor to the current line level and push it.
5. Rotate the encoder to change the setting and confirm by pushing the encoder again.
To adjust the output line level on the web remote:
1. Select an analog output channel by clicking the corresponding channel strip. The channel strip turns
blue.
2. (optional) Click and drag left or right to select multiple channels.
3. Press one of the buttons for +13 dBu, +19 dBu or +24 dBu below the selection. The selected value is
shown within the level meter.
10.2.2. Mute Analog Outputs
RME M-32 DA Pro User's Guide
Cursor (current channel)
Input Reference Level
10.2. Analog Outputs | 44
Advertisement
Table of Contents
