Table of Contents
Advertisement
11.2.1. Selecting a Master Clock
To configure the clock master on the device:
1. Enter the CLOCK section. The cursor highlights the currently selected clock.
2. Push the encoder. Two blue arrows are shown to indicate that the encoder can now be used to
change the current setting.
3. Rotate the encoder until the preferred clock source is shown.
4. Push the encoder again to activate the setting.
To configure the clock master on the web remote:
1. Locate the CLOCK section.
2. Use the Master: dropdown menu to choose a clock source. The new clock source is applied
immediately.
11.3. Sample Rates Overview
The M-32 DA Pro supports the following sample rates:
Supported sample rates
Single speed
Double speed
Quad speed
If the device is clock master, these rates always correspond to the actual sample rate used.
11.3.1. Slave Mode
When the device is slave, certain deviations are automatically accepted to avoid interruption of the
outgoing audio signal when the sample rate changes. This is called Intelligent Clock Control (ICC). It also
handles deriving a sample rate of double or quad speed based on an incoming rate.
Intelligent Clock Control (ICC)
Input
MADI
MADI
MADI
MADI
MADI
MADI
51 | 11.3. Sample Rates Overview
RME M-32 DA Pro User's Guide
Clock at input
44.1
44.1
44.1
44.1
44.1
44.1
44.1 kHz, 48 kHz
88.2 kHz, 96 kHz
176.4 kHz, 192 kHz
Selected Sample Rate
44.1
48
88.2
96
176.4
192
Resulting Sample Rate
44.1
44.1 with warning
88.2
88.2 with warning
176.4
176.4 with warning
Advertisement
Table of Contents
