Atag CM4585M Instructions For Use Manual page 38

Troubleshooting
Table continued from last page
Problem
Coffee does not come out of one
or both of the spouts.
The appliance does not make
coffee.
The appliance does not come
on.
The brewing unit cannot be
removed.
The appliance makes a weird
sound (not as normal).
At the end of descaling, the
appliance requests a third rinse.
The milk does not come out of
the milk spout.
The milk contains large bubbles
and squirts out of the milk spout
or there is little froth.
38
Possible cause
The coffee spouts are blocked.
The appliance has detected
impurities in its internal circuits.
See the information shown on
the display.
The appliance is not set to On'.
The appliance has not been set
to Standby' correctly.
The drip tray has not been
removed.
The brewing unit is not in the
correct position.
The brewing unit and the infuser
are dirty.
During the two rinse cycles, the
water tank has not been filled to
the MAX level.
The lid of the milk container is
dirty.
The milk is not cold enough or
is not semi-skimmed or
skimmed.
The milk froth adjustment knob
is incorrectly adjusted.
The lid of the milk container or
the milk froth adjustment knob
is dirty.
The hot water connection nozzle
is dirty.
Solution
Clean the coffee spouts.
Wait for the appliance to be
ready for use again and select
the required beverage again.
Push the main switch to set the
appliance to On'.
Push the On button to set the
appliance to On'.
Push the Standby button to set
the appliance to Standby'.
Remove the drip tray.
Close the door and set the
appliance to On'. The brewing
unit automatically returns to the
correct position.
Clean the infuser and all parts
of the brewing unit. Lubricate
the O-rings with the lubricating
grease.
Obey the instructions shown on
the display.
Clean all components of the milk
container.
Use skimmed or partially
skimmed milk at refrigerator
temperature (about 5 °C). If the
result is not as you wish, try
changing the brand of milk.
Adjust the milk froth adjustment
knob.
Clean all components of the milk
container.
Clean the nozzle.