Block Heater (Option); Stopping The Engine - Kubota B2301-1 Operator's Manual

8. Turn the key to "PREHEAT" position
and hold it for about 2 to 3 seconds.
For the appropriate preheating time, refer to the table
below:
Temperature
Over 0 C (32 F)
0 to -5 C (32 to 23 F)
-5 to -15 C (23 to 5 F)
A Glow plug indicator (5) comes on while engine is being
preheated.
9. Turn the key to "START" position and
release when the engine starts.
A Because of the safety devices, the engine will not start
except when the PTO clutch lever is placed in the
"OFF" position and speed control pedal is placed in the
"NEUTRAL" position.
C Cold Weather Starting
When the ambient temperature is below -5
the engine is very cold. If the engine fails to start, turn off
the key for 30 seconds. Then repeat steps 8 and 9. To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 10
seconds.
BBlock Heater (Option)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -15
10. Check to see that all the lamps on the
Easy Checker (TM) are "OFF".
If any lamps stays on, immediately stop the engine and
determine the cause.
Preheating Time
2 to 3 sec.
5 sec.
10 sec.
(23 ) and
(5 ).
OPERATING THE ENGINE

STOPPING THE ENGINE

1. After slowing the engine to idle, turn the
key to "OFF".
2. Remove the key.
A If key does not stop the engine, consult your local
KUBOTA Dealer.
13