Measurement Specifications; Power Consumption; Maintenance - Ambient Weather WS-1401-IP User Manual

8.2 Measurement Specifications

The following table provides the specifications for the measured parameters.
Measurement
Indoor Temperature
Outdoor Temperature
Indoor Humidity
Outdoor Humidity
Barometric Pressure
Light
Rain
Wind Direction
Wind Speed

8.3 Power Consumption


ObserverIp Receiver : 5V DC Adaptor (included)

Indoor Thermo-hygrometer-barometer sensor : 2xAAA batteries (not included)

Outdoor sensor array: 3xAA batteries (not included)

9. Maintenance

1. Clean the rain gauge once every 3 months as follows. Reference Figure 41.
Step 1: Make a note of the current rain totals by referencing the calibration panel (reference
Section 1.8.4.1. You will need to re-enter these values after the calibration procedure it
complete.
Step 2: Pour water into the rain collector to moisturize the dirt inside rain bucket.
Step 3: Use an approximately 3 inch (80 mm) long cotton swab, and push the cotton tip
through the rain collector hole until is reaches the self emptying mechanism, and press until
the mechanism no longer rotates.
Step 4: Rotate the cotton swab back and forth, removing dirt from the tipping mechanism and
rain collector hole.
Step 5: Remove the cotton swab and flush with water to remove any remaining dirt.
Step 6: Re-enter the rain totals recorded in Step 1.
Version 2.0 ©Copyright 2017, Ambient LLC. All Rights Reserved.
Range
32 to 140 °F
-40 to 149 °F (lithium
batteries)
-4 to 140 °F (alkaline
batteries)
1 to 99%
1 to 99%
8.85 to 32.50 inHg
0 to 400,000 Lux
0 to 394 in.
0 - 360 º
0 to 100 mph (operational)
Accuracy
± 2 °F
± 2 °F
± 5%
± 5%
± 0.08 inHg (within range of
27.13 to 32.50 inHg)
± 15%
± 10%
1º
± 2.2 mph or 10% (whichever
is greater)
Resolution
0.1 °F
0.1 °F
1 %
1 %
0.01 inHg
1 Lux
0.01 in
1º
0.1 mph
Page 39