Advertisement
Setting the menu (cont.)
REMOTE SETTING
Settings for the external control.
Item
SERIAL TYPE
PARALLEL TYPE
PIN1
PIN2
PIN3
PIN4
PIN5
PIN6
PIN7
PIN8
INFORMATION
Settings for the information display of the monitor.
Item
POSITION
SOURCE ID
CHARACTER SET. *
1
STATUS DISPLAY
TIME CODE
CRC ERROR
SUB HOUR METER
MODEL
VERSION
HOUR METER
*
Memorized for each input.
1
*
2
Ancillary time code
20
(☞ "External Control" on pages 22)
Content
Select the input terminal used for external control by serial
communication.
Select the external control method for the MAKE/TRIGGER terminal.
Assign the control functions to the pins of the MAKE/TRIGGER terminal.
• Assign a function to each pin terminal by selecting "SET" in "PARALLEL
TYPE" mentioned above.
The functions are assigned for "PIN6" – "PIN8" and you cannot change the
assignment of these functions.
Content
Select the position to show the information display (☞ "On the
Information Display" on page 11).
Select whether the name assigned in "CHARACTER SET." (☞ below) is
displayed on the screen (☞ "On the Information Display" on page 11).
• When "AUTO" is selected, the display color synchronizes with the color
of the tally lamp (☞ page 8) while the tally lamp is lit.
Assign a name to each video source as you like (10 characters at maximum).
You can also enter a name using the RS-232C system.
Setting of "CHARACTER SET."
1
Change the input to one that you want to assign a video source
name for.
2
Select "CHARACTER SET."
3
Press the
buttons to select a character to enter at first.
●
Each time you press the
following order. Press
space
4
Press
button to move the arrow to the next space.
●
The characters entered before moving the arrow are memorized.
5
Repeat steps 3 and 4 (10 characters at maximum).
6
Press MENU button to store the name.
Select whether the status of the current input and the setting of MUTING
are displayed on the screen (☞ "On the Status Display" on page 12).
Select the type of the TIME CODE display.
Select whether the CRC error indication for the input HD SDI/SD SDI or 3G
SDI signal is displayed on the screen (☞ "On the Information Display" on
page 11).
Display the hours of use (unit: hour).
You can reset this item.
Display the model name of the monitor.
Display the version of the monitor.
Display the total hours of use (unit: hour).
This item is used for maintenance of the monitor. You cannot reset this item.
button, the characters change in the
button to reverse the order.
Setting value
RS232C
RS485
MAKE, TRIGGER, SET
☞ "Functions controlled by the
MAKE/TRIGGER system" on page 23.
☞ "Using the MAKE/TRIGGER
system" on page 22
Setting value
UPPER
LOWER
OFF
ON
AUTO
AUTO, OFF, ON
VITC *
, LTC *
, D-VITC
2
2
OFF
ON
Advertisement
