Advertisement
SCOPE SETTING
Configure the settings for the wave form monitor and vector scope.
Item
Content
GAIN
Adjust the input gain level.
SIZE *
Set the window size.
2
POSITION *
Select the window position.
2
TRANSPARENT
Activates/deactivates the function to make the window translucent.
ON
OFF
AUTO OFF
Set the function to turn off the window automatically 15 minutes after displayed.
WAVE DISPLAY
Select a wave form to be displayed for the wave form monitor.
WAVE FILTER
Turn on/off the lowpass filter to put over the input wave form data.
WAVE OVER LEVEL
Set the over levels of the luminance signals (Y) and RGB signals.
(Configure the
Example of the wave form monitor
following items)
Ex.: When the luminance signal is Y, "MARKING" is set to "ON" and "LEVEL" is set to
• The wave form color of signals over the value specified in "LEVEL" turns red.
• The display differs depending on the input signal or the "WAVE DISPLAY" setting.
MARKING
Turn on/off the function to change the wave form color of signals over the value
specified in "LEVEL." (☞ below)
LEVEL
Adjust the lower limit for the over level.
*
1
The wave form monitor is not displayed when the input signals are DVI (input from a computer). The vector scope is not displayed when the input
signals are RGB.
*
2
When "SIZE" is set to "LARGE," the window is displayed in the center of the screen regardless of the "POSITION" setting.
SYNC FUNCTION
Settings for the synchronization with signals.
Item
Content
NO SYNC ACTION
Select the screen status when no signal is coming in.
P.SAVE
GRAY B.
DELAY TIME
Select the period until the screen status changes as selected in "NO SYNC ACTION" after
signals stop coming in.
LOW LATENCY
Activates/deactivates the function to shorten the time taken to display the picture.
• If the picture is not displayed steadily while "ON" is selected, select "OFF."
• While "ON" is selected, the displayed picture may become unstable when an operation
using buttons on the front panel or the menu is performed, or when the signal format
changes.
●
When setting "NO SYNC ACTION" to "GRAY B.," the screen color changes to gray and the power consumption of the back light is saved by
half. Selecting "P.SAVE" (power save mode) saves more power consumption by turning off the back light.
●
In the initial setting, "NO SYNC ACTION" is set to "P.SAVE", and "DELAY TIME" set to "15min." Change the settings if necessary. (U.S.A. only)
*1
:
Translucent
:
Normal
"080"
Red
Y
Start
:
Power save mode
:
Gray screen
White
Image signals
End
Setting value
–10 – +10
NORMAL, LARGE
1 (Lower right), 2 (Lower left)
3 (Upper left), 4 (Upper right)
ON
OFF
ON, OFF
Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
FLAT (No filter)
LOWPASS
Example of the vector scope
Ex.: When the color bar is
displayed
OFF, ON
070 – 109
Setting value
OFF
P.SAVE
GRAY B.
30sec., 5min., 15min.
ON
OFF
17
Advertisement
