Check The Air Filter; Start The Engine - Zipper Mowers ZI-STE2000IV User Manual

10.1.3 Check the air filter

Check the core of the air filter, ensuring that it is
clean and performs well.
Dismantle the repair cover, loosen the screw on
the cover of the air filter, and then dismantle the
cover of the air filter to check the core.
Please clean or change the core if necessary.
A – Screw of the repair cover (Fig. I)
C – Air filter (Fig. J)
E – Screw of the air filter (Fig. J)

10.2 Start the engine

Totally turn the valve to the "ON" position clockwise and ESC to the position "0" =

OFF.
 Turn the switch of the engine to the "ON" position. (Fig. L)
 Turn the pulling pole of the air-blocking valve to the "START" position. (Fig. M)
Pull the starting hold (Fig. N) slightly until you
feel the pressure, then release the hold slowly by
hand.
When the engine is warming up, turn the pulling
pole of the air-blocking valve to the "RUN"
position.(Fig. O)
1 – Run / operate (Fig. O)
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE2000IV
B – Repair cover (Fig. I)
D – Cover of the air filter (Fig. J)
F – Core of the air filter (Fig. J)
2 – air-blocking valve (Fig. O)
Do not run the engine without the
air filter, or else filth will enter the
engine through carburetor,
resulting in quick wear and tear of
the engine.
I M P O R T A N T
when the engine is hot or the
environmental temperature is
relatively high turn the pulling pole
of the air-blocking valve to the
"RUN" position.
Do not let the starting hold (Fig. N)
rebound, and release it slowly by
hand.
If the engine can not restart after
halting, check the oil level ahead of
other failures.
3 –operating position
OPERATION
28